iBike Gen III Operating Instructions Manual page 44

USING THE INDOOR TRAINER FEATURE
The Indoor Trainer feature allows you to measure power with your iBike when using many
models of indoor trainers and rollers. Consult the iBike software, "Device/Edit Trainer
Settings..." for a complete list of supported trainers and rollers.
When using the indoor trainer function your iBike must measure the speed of the rear
wheel. Therefore, you will need to use a wireless mount, with speed sensor mounted on
the rear wheel. The iBike uses the trainer profile to estimate the power required to
produce the measured rear wheel speed.
The Indoor Trainer function is standard on the iAero and is an optional upgrade for the iPro
and iSport. For iSport models only, the Indoor Trainer function is installed at the factory,
or by an authorized iBike dealer.
Here's how turn the Indoor Trainer function "On":
1) Make sure your speed sensor is mounted on the rear wheel of your bike
2) (iPro and iAero only) Use the iBike software to install the select and install the
profile for your indoor trainer, "Device/Edit Trainer Settings..."
3) iSport only: a generic indoor trainer profile has been installed at the factory. Your
authorized iBike dealer can change the profile for your iSport.
4) To turn the trainer function ON, enter Setup and click the bottom arrow repeatedly
to find "User". If "User/No" is on the screen, click the center button to make the
word "Yes" flash. Then, click the center button so that "User/Yes" is displayed
without any flashing.
5) With "User/Yes" shown, click the up arrow one time. "Trnr" is shown. If "Trnr/Off"
is shown, click the center button so that Off flashes. Click the up arrow so that
"Trnr/On" flashes.
6) Exit Setup. Your iBike is ready to use with your indoor trainer.
7) When downloading ride files recorded with the Indoor Trainer function On, the
status window of your iBike software will read "Indoor Trainer".
How to turn the Indoor Trainer function "Off":
When riding outdoors you need to turn your Indoor Trainer function off so that the iBike's
power measurement sensors will function normally:
1) To turn the trainer function Off, enter Setup and click the bottom arrow repeatedly
to find "User". If "User/No" is on the screen, click the center button to make the
word "Yes" flash. Then, click the center button so that "User/Yes" is displayed
without any flashing.
2) With "User/Yes" shown, click the up arrow one time. "Trnr" is shown. If "Trnr/On"
is shown, click the center button so that "On" flashes. Click the up arrow so that
"Trnr/Off" flashes.
3) Exit Setup. Your iBike is ready to use on your outdoor rides.
NOTE: YOUR IBIKE MAY NOT PROVIDE ACCURATE WATTS READINGS
IF "TRNR/ON" IS SET DURING OUTDOOR RIDES.
Click the center button to accept. "Trnr/On" is shown.
Click the center button to accept. "Trnr/Off" is shown.
43
Copyright Velocomp LLP 2005-2011