iBike Gen III Operating Instructions Manual page 20

iBike TRIP DATA AND RIDE FILES
iBike "Trips"
The iBike gathers, stores, analyzes, and displays data as "trips".
trip is recorded in a "Ride File".
Generally, each time you start a new day's ride you'll want to start a new iBike trip. A
simple and fast "Trip-Reset" (described below) closes the previous ride file and creates a
new iBike Trip and opens a new ride file.
Also, if your iBike Pro or iBike Aero sleeps for more than 4 hours it will automatically begin
a new Trip and ride file.
An iBike "Trip Reset" starts a new ride file and resets the iBike screens with zero readings
of:
Trip odometer
•
Trip time
•
Lap Timer and lap stats
•
Instantaneous, average and maximum:
•
Power
kilojoules
speed
hill slope
wind speed
elevation gain
Starting a New Trip (Trip-Reset):
You can start a new trip and new ride file at any time. Here is how:
1. Click and hold the center button for two seconds.
2. The screen says "trip reset". The word "trip" does not flash and the word
"reset" does flash.
3. To confirm your trip-reset, click the center button again. Both words
("trip", "reset") will flash, then the main screen will return.
4. If you decide you DON'T want to complete the trip-reset, cancel the trip reset
by waiting for four seconds, or by clicking any button EXCEPT the center button.
The message "not rESEt" will appear and will remain on the screen until you click
the center button.
IMPORTANT: UNLESS YOU CONFIRM THE TRIP RESET BY CLICKING THE CENTER
BUTTON A SECOND TIME, YOU WILL NOT COMPLETE THE TRIP RESET AND YOU WON'T
START A NEW RIDE FILE!
TIP: You can do a trip reset any time, even while riding.
19
Copyright Velocomp LLP 2005-2011
Information from each