iBike Gen III Operating Instructions Manual page 41

You can see, and change, your FTP number as follows:
1) Go to Setup/RACR YES/FTP CFG.
2) Click the center button; the bottom screen flashes and shows your current value of
FTP. If you've done a Fitness Test, the FTP is based on the Fitness Test. If you
haven't done a fitness test, a default value o 0001 (1Watt) will be shown
3) If you wish to change the FTP number do so
4) To accept your choice or exit the item, click the center button to accept. "done"
flashes and the iBike proceeds to the next RACR screen, "CDA"
CDA ON/OFF (iAero only)
•
CdA is an important aerodynamic measurement that can be displayed on the screen of the
iAero only. You can read about CdA measurements in your iAero manual.
If you wish to see CdA measurement on the bottom window of your iAero power screen do
the following:
1) Go to Setup/RACR YES/CDA ON-OFF.
2) Click the center button; the bottom screen flashes. To turn CDA on select "ON" with
the up arrow.
3) If you don't want to see CdA measurements on your iAero click the up arrow to
select "OFF".
4) To accept your choice click the center button; the screen flashes "done" and the
iBike advances to the next menu item, "TOTAL HRS LOG"
TOTAL HRS LOG
•
You can set the iBike's hours-on-bike log to start at a number other than the default
number of zero. This is a handy feature if you want to copy this value from your old bike
computer. Click the center button to set the log; when finished, click the center button to
accept. "done" will flash and the iBike will move to the next screen, "TOTAL ODO"
CAD ON/OFF (cadence display on/off)
•
For iBikes with cadence sensors, the display of the cadence measurement is turned on or
off in this setting. The default value is On; cadence (and HR if available) alternate back
and forth in the bottom window of the Power Screen. if Cad is set to "off", then cadence will
not be shown in the bottom window of the power screen. If you are using an HR strap and
Cad is "Off", then HR will be shown continuously.
TOTAL ODO (total Odometer)
•
You can set the iBike's odometer to start at a number other than the default number of
zero. This is a handy feature if you want to copy your odometer setting from your old bike
computer. Click the center button to set the log; when finished, click the center button to
accept. "done" will flash and the iBike will move to the next screen, "RACR NO"
IMPORTANT: UPON COMPLETION OF THE "TOTAL ODO" SETTING YOU WILL EXIT THE RACR
SEQUENCE AND THE IBIKE WILL AUTOMATICALLY CHANGE THE SETTING TO "RACR NO".
40
Copyright Velocomp LLP 2005-2011