iBike Gen III Operating Instructions Manual page 6

IBIKE SETUP AND CALIBRATION PROCESS
Before using your iBike on the road, it is essential to complete a one-time setup and
calibration process for each bike. YOUR IBIKE WON'T WORK PROPERLY UNTIL THE
SETUP PROCESS HAS BEEN COMPLETED.
The setup process involves two simple steps:
1) Enter information into the iBike's memory. This is done through "Setup" screens
and setup "Sequences" The "Fast Start" sequence is mandatory.
2) Perform a 2 mile long calibration ride
IMPORTANT: Your iBike won't work properly until steps 1) and 2) are performed.
If you are a very fast rider (speeds on the flats regularly above 22 mph), or want to take
advantage of some of the iBike's advanced measurement capabilities, you may want to
consider optional coast down measurements. To learn more about coast downs, see Part
Two of these instructions (pages 30-32), and refer also to the iBike Software instructions.
5
Copyright Velocomp LLP 2005-2011