iBike Gen III Operating Instructions Manual page 13

TIP: IT'S OK TO RIDE OUT MORE THAN ONE MILE. AS LONG AS YOUR BIKE SPEED
REMAINS ABOVE 10 MPH THE IBIKE WILL CONTINUE TO RECORD DATA EVEN WHILE
FLASHING "GO BAC". IF YOU RIDE MORE THAN ONE MILE YOUR CAL RIDE WILL BE EVEN
MORE ACCURATE; A FOUR MILE OUT-AND-BACK RIDE IS EXCELLENT!
14) As you ride back your iBike distance measurement will count down to zero, telling
you how much distance remains until the end of the Cal Ride.
IMPORTANT: RIDE BACK ON THE SAME ROADS
17) At the end of your calibration ride your iBike will notify you that the cal ride is done
("Cal Done"). After a few seconds your iBike will exit setup.
RACER TIP: IF YOU DECIDE TO DO COAST DOWNS, DO THEM IMMEDIATELY AFTER
YOUR CALIBRATION RIDE. ALSO, DO NOT ERASE YOUR RIDE DATA AFTER YOUR CAL RIDE
AND PRIOR TO YOUR COAST DOWNS!
NOTICE: ONCE BEGINNING YOUR CAL RIDE, IF YOU WISH TO TERMINATE IT, PRESS-
HOLD THE CENTER BUTTON FOR TWO SECONDS. THIS ABORTS THE CAL RIDE AND
LEAVES ANY PRIOR RESULTS UNCHANGED.
YOUR IBIKE IS NOW READY TO RIDE!!!
12
Copyright Velocomp LLP 2005-2011