iBike Gen III Operating Instructions Manual page 15

Any Setup data you have entered and any calibrations you have performed are stored in
"Profile 1".
To select Profile 2, click the up arrow and use the up arrow to change the setting to "Prof
2" (Profile 2). To accept your choice of Profile 2, click the center button.
After selecting Profile 2, any Setup entries and any Calibration Rides made afterwards will
be stored on your iBike in the "Profile 2" memory.
REMEMBER: YOU MUST PERFORM A "FAST START" SEQUENCE AND CALIBRATION RIDE
FOR EACH BIKE.
REMEMBER: IF YOU HAVE A WIRELESS MOUNT, YOU'LL NEED TO "SCAN" YOUR
WIRELESS SENSORS FOR EACH BIKE. SEE INSTRUCTIONS ON PAGES 23-26 TO PERFORM
A WIRELESS "SCAN".
USING PROFILES
If you have two different profiles stored in your iBike, say for two different bikes, to use
your iBike's Profile 2 with bike #2, enter setup, scroll to Set Prof, select "Prof 2", then click
the center button to accept. Exit setup. Your iBike will now load all the settings for Profile
2 into memory and you're ready to ride.
14
Copyright Velocomp LLP 2005-2011