Installation And Start-Up; Safety Considerations - Ametek WDG-V User Manual

This chapter describes how to install the WDG-V Analyzer components and
Display User Interface.

Safety Considerations

PN 9000-133-VE, Rev U

Installation and Start-up

If you have an Oxygen-only analyzer without the combustibles option,
the combustibles and methane options described in this chapter do
not apply. The combustibles and methane sections are clearly identi-
fied. Likewise, if you have the combustibles option, but not the meth-
ane option, you can skip all sections pertaining to methane.
Before beginning the installation of the analyzer and before powering
it up, review and follow all safety information following the Table of
Contents near the beginning of this manual. This information de-
scribes procedures to follow to avoid personal injury and/or damage
to the equipment. All regulatory agency and personnel safety proce-
dures for your jurisdiction must be followed.
The installation of the analyzer must be in accordance with all of the
customer and local regulatory standards and procedures. There are no
operator-serviceable components inside the analyzer. Refer all servic-
ing to qualified personnel.
Do not turn on the aspirator until the analyzer has been turned on and
is hot – preferably 24 hours. If you turn off the analyzer or the process
is shut down, turn off the aspirator to avoid plugging problems.
Installation and Start-Up
|
2-1