Mounting The Switch In A Four-Post Rack; Connect The Switch To A Power Source; Install Transceivers (Optional) - Aruba 6300F Series Installation And Getting Started Manual

2. Use the four number 12-24 screws to secure the brackets to the rack.

Mounting the switch in a four-post rack

The four-post rack mount for the switches requires the optional J9583A HPE X410 Universal Rack Mounting
Kit. To use this kit to mount a switch, see the installation instructions provided with the kit.

Connect the switch to a power source

For AC power supplies: Plug the included power cord into the power connector on the switch and into a
nearby AC power source.
For DC power supplies: Use the supplied DC power cable with the DC power supply. Follow the instructions
in Install a power supply or a second power supply for modular switches
to the power supply and DC power source.
When powered by a DC power supply, the product relies upon the installation to provide short-circuit (overcurrent)
protection. Ensure that the protective device is not greater than 20A for non-PoE switches and not greater than
40A for PoE switches when using DC power.
Make sure the power source is properly grounded before connecting power to the power supply.
Warning: A readily accessible two-pole disconnect device must be provided in the fixed installation.
Recheck the LEDs during self-test.

Install transceivers (optional)

You can install or remove transceivers from the slots on the front of the switch without having to power off
the switch.
to connect and install the DC cable
Installing the switch | 30