Aruba 6300F Series Installation And Getting Started Manual page 39

Unplugging the DC power supply when the PSU is powered on is not supported.
AC power supply
1. Remove the AC power cable from the connector on the failed power supply.
2. Grasping the handle of the failed power supply, release the locking mechanism by squeezing the latch
handle while removing the failed power supply.
Figure 1 Replacing a Failed Power Supply
Table 10: Replacing Failed Power Supply: Label and Description
1
2
Aruba 6300F/M Switch Series Installation and Getting Started Guide | (xxxx Switch Series)
Label Description
Lock mechanism
Handle
39