Dalsa Everywhereyoulook Linea Lite GigE User Manual page 57

Device Built-In Self Test
Status
Passed
Firmware update failed
Sensor Initialization
Failure
Firmware Error
Unexpected Error
Device Built-In Self Test
Status All
Device Reset
Device Temperature
Selector
Internal
MaxInternal
Device Temperature
Power-up Configuration
Selector
None
Factory Setting
UserSet1
UserSet2
UserSet3
UserSet4
User Set Selector
Factory Setting
UserSet 1
UserSet 2
UserSet 3
UserSet 4
Load Configuration
Save Configuration
DeviceID
Linea Lite GigE Series Camera
deviceBISTStatus
Passed
FirmwareUpdateFailure
SensorFailure
FirmwareError
Unexpected_Error
deviceBISTStatusAll
DeviceReset
DeviceTemperatureSelector
Internal
MaxInternal
DeviceTemperature
UserSetDefault
None
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSetSelector
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSetLoad
UserSetSave
DeviceID
Return the status of the device Built-In Self test. Possible
return values are device-specific.
No failure detected
Last firmware update operation failed.
There was an error initializing the sensor; the camera may
not be able to capture images.
Firmware encountered an error during streaming.
Switched to recovery mode due to unexpected software
error.
Return the status of the device Built-In Self Test as a bitfield.
The meaning for each bit is device-specific.
Resets the device to its power up state. (W)
Select the source where the temperature is read.
Read FPGA and/or PHY temperature.
Records the highest device temperature since power up.
Value is reset on power off.
The temperature of the selected source in degrees Celsius
Selects the camera configuration set to load and make active
on camera power-up or reset. The camera configuration sets
are stored in camera non-volatile memory. (RW)
Keep Internal configuration.
Load factory default feature settings.
Select the user defined configuration UserSet 1 as the Power-
up Configuration.
Select the user defined configuration UserSet 2 as the Power-
up Configuration.
Select the user defined configuration UserSet 3 as the Power-
up Configuration.
Select the user defined configuration UserSet 4 as the Power-
up Configuration.
Selects the camera configuration set to load feature settings
from or save current feature settings to. The Factory set
contains default camera feature settings. User camera
configuration sets contain features settings previously saved
by the user. (RW)
Select the default camera feature settings saved by the
factory.
Select the User Defined Configuration space UserSet1 to save
to or load from features settings previously saved by the
user.
Select the User Defined Configuration space UserSet2 to save
to or load from features settings previously saved by the
user.
Select the User Defined Configuration space UserSet3 to save
to or load from features settings previously saved by the
user.
Select the User Defined Configuration space UserSet4 to save
to or load from features settings previously saved by the
user.
Loads the camera configuration set specified by the User Set
Selector feature, to the camera and makes it active. (W)
Saves the current camera configuration to the user set
specified by the User Set Selector feature. The user sets are
located on the camera in non-volatile memory. (W)
Displays the device's factory set serial number.
Operational Reference • 55
Beginner
DFNC
Beginner
DFNC
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Invisible