Dalsa Everywhereyoulook Linea Lite GigE User Manual page 125

External Output Details
• The outputs signals can be used in programmable output mode such as strobe, event
notification, etc.
(see outputLineSource
• For the Single-Ended Open Drain outputs, the user supplied Pull-up resistor value should be
between 1K and 10K depending on supply rail. Resistor Wattage should be calculated
accordingly.
• Outputs are open (disabled) on power-up with the default factory settings.
• A software reset will not reset the outputs to the open state if the outputs are active.
• A user setup configured to load on boot will not reset the outputs to the open state if the
outputs are active.
• The output signals are designed to prevent an output signal glitch on power-up or polarity
reversal.
• Protection Circuit – DC Ratings:
• Output protected against shorts to ground or other voltages
• Output maximum voltage of 26V at 10 mA, (60°C)
Linea Lite GigE Series Camera
feature).
Technical Specifications • 123