I/O Module Block Diagram - Dalsa Everywhereyoulook Linea Lite GigE User Manual

Output Line Pulse Delay
Output Line Pulse Duration
Output Line Value
Active
Inactive
Line Status All
Output Line Software
Command

I/O Module Block Diagram

Input
Line Selector =
Line 1 to 6
Physical
Line
Output
Linea Lite GigE Series Camera
outputLinePulseDelay
outputLinePulseDuration
outputLineValue
Active
Inactive
LineStatusAll
outputLineSoftwareCmd
Line
Line Input
Detection
Debouncer Inverter
Level
Line
Mode
Input
LineStatus
or
Output
Output
Pulse
Inverter
Generator
Output
Line
Source
Sets the delay (in µs) before the output line pulse signal.
Applicable for the OutputLineSource feature. Note, the
LineMode feature must be set to output.
Sets the width (duration) of the output line pulse in
microseconds.
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF. OutputLineSource
must be SoftwareControlled. If the
outputLineSoftwareLatchControl = Latch , the state of the
pin will change with the outputLineSoftwareCmd
command.
Sets the Output circuit to close
Sets the Output circuit to open
Returns the current status of all available line signals, at
time of polling, in a single bitfield. The order is Line1,
Line2, Line3, ... (RO)
Writing a value of 1 in the bit field applies the Latch value
of the outputLineSoftwareLatchControl and/or executes
the PulseOnSoftwareCmd for any output line programmed
for software control. The feature outputLineSoftwareCmd
can take any binary value and each bit set to 1
corresponds to a Icommand for an Output.
Bit-0 is Line 3,
Bit-1 is Line 4,
Bit-2 is Line 5,
Bit-3 is Line 6
This is applicable to OutputLineSource = Pulse On: where
Software Cmd (for Pulse mode) or OutputLineSource =
SoftwareControlled and OutputLineSoftwareLatchControl =
Latch (for static states).
Timer and Counter Module
TimerEnd Event
Timer
Event Driven
Counter
CounterEnd Event
Trigger Module
Trigger
Trigger
Line
Source
Activation
Software Driven
Event Driven
Signal Driven
Software Driven
Trigger Signal
Software Trigger
Cmd
Operational Reference • 65
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Expert
1.0Expert
DFNC