Sony STR-DA3600ES Operating Instructions Manual page 23

Notes
• When you connect all the speakers with a nominal
impedance of 8 ohms or higher, set "Impedance" in
the Speaker settings menu to "8 ohms." In other
connections, set it to "4 ohms." For details, see "9:
Setting the speakers" (page 43).
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
Tips
• You can loosen or tighten the SPEAKERS terminal
easily using the supplied speaker cord connection
tool.
Loosen
Tighten
• To connect certain speakers to another power
amplifier, use the PRE OUT jacks. The same signal
is output from both the SPEAKERS terminals and
the PRE OUT jacks. For example, if you want to
connect just the front speakers to another amplifier,
connect that amplifier to the PRE OUT FRONT L
and R jacks.
ZONE 2 connection
You can assign the SURROUND BACK/
FRONT HIGH/ZONE 2 terminals F and G
to the speakers of the zone 2. Set "Sur Back
Assign" to "ZONE2" in the Speaker settings
menu.
See "Using Multi-zone Features" (page 90)
for details on connection and operation in
zone 2.
Note
If the speaker pattern is set so that there are surround
back speakers or front high speakers, you cannot use
the speakers of the zone 2 as intended.
Speaker cord
connection tool
23 GB