Download  Print this page

Advertisement

Table of Contents
3
Press V/v repeatedly to select
"Auto Calibration," then press
.
4
Press V/v repeatedly to select
"Calibration Start," then press
.
The screen on which you can select the
item to be measured appears.
5
Press V/v repeatedly and
un-check the items you do not
want to measure, then press b.
The confirmation screen, asking whether
you are ready to start measurement,
appears.
48
GB
6
Press
The measurement starts in five seconds.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
When the measurement ends, a beep
sounds and the screen switches.
7
Press V/v repeatedly to select
the item you want, then press
.
Item
Retry
Save
to
Warning
Phase
Distance
Level
Exit
to select "Start."
Explanation
Performs auto calibration
again.
Saves the measurement
results and exits the setting
process. See "Saving the
measurement results"
(page 49).
Displays warning
concerning the
measurement results. See
"Message list after auto
calibration measurement"
(page 50).
Displays the phase of each
speaker (in phase/ out of
phase).
Displays the measurement
result for speaker distance.
Displays the measurement
result for speaker level.
Exits the setting process
without saving the
measurement results.

Advertisement

Table of Contents

   Related Manuals for Sony STR-DA3600ES

Comments to this Manuals

Symbols: 0
Latest comments: