8: Preparing The Receiver And The Remote - Sony STR-DA3600ES Operating Instructions Manual

8: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Connect the supplied AC power cord (mains
lead) to the AC IN terminal on the receiver,
then connect the AC power cord (mains lead)
to a wall outlet.
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed
be connected this way. This is not malfunction.
42
GB
AC IN terminal
To the wall outlet
AC power cord
(mains lead)
(supplied)
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
?/1
TONE MODE
1
Press ?/1 to turn off the
receiver.
2
While holding down the TONE
MODE and 2CH/A.DIRECT,
press ?/1 to turn on the
receiver.
3
Release the TONE MODE and
2CH/A.DIRECT after a few
seconds.
After "CLEARING" appears on the
display for a while, "CLEARED !"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Note
It takes about 30 seconds for the memory to be
cleared completely. Do not turn the receiver off until
"CLEARED !" appears on the display.
To reboot the receiver
If the buttons on the receiver or the remote do
not work due to a malfunction of the receiver,
reboot the receiver.
1
Press ?/1 to turn off the receiver.
2CH/A.DIRECT