Operation; Safety Instructions For Operation; Turning On/Off; Hotspot Mode - SHOWTEC EventDOT 15 Q4 User Manual

Table of Contents

Advertisement

EventDOT 15 Q4
6.

Operation

Safety Instructions for Operation

Attention
This device must be used only for the purposes it is designed for.
This device is designed to be used as a professional light effect suitable for stage lighting, corporate and
private events. This device is not suitable for households and for general lighting.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.

Turning On/Off

The device has a power switch.
Set the power switch (14) to ON position to turn on the device.
Set the power switch (14) to OFF position to turn off the device.
Make sure that the device is turned off from the power switch (14) when the device is not in use. This will
prevent the battery from depletion.
It is recommended to reset the device to its factory settings after each setup or use. Refer to 6.4. Factory
Reset on page 19 for more information. When you turn off the device, the next time you turn it on, it will
continue to operate in the previously selected operation mode.

Hotspot Mode

When you start the device for the first time, it enters by default in hotspot mode. When the device is in
hotspot mode you can establish a Wi-Fi connection with a computer, laptop, tablet or smartphone. The
IP address of the device in hotspot mode is 192.168.4.1.
To activate hotspot mode, you need to reset the device to the factory settings. See 6.4. Factory Reset on
page 19 for more information.
In hotspot mode the Wi-Fi LED indicator (08) is off.

Factory Reset

It is recommended to reset the device to its factory settings after each setup or use. If you do not reset
the device, the next time you turn it on, it will continue operating in the last selected operation mode.
After factory reset, when you turn on the device, it will enter into hotspot mode.
If the device is turned off, to reset the device follow the steps below:
Set the power switch (14) to ON position to turn on the device.
Press and hold down the reset button (15) together with the manual control button (10) for 5 seconds.
To access the reset button (15), use a pin or a thin screwdriver.
If the device is switched on in manual control mode (see 6.6.1.1. Switching on the Device on page 20), to
reset the device follow the steps below:
Press and hold down the reset button (15) for 5 seconds. To access the reset button (15), use a pin or
a thin screwdriver.
Product code: 44011
19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EventDOT 15 Q4 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

44011

Table of Contents