ColorCue 2 AIR
6.
Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for use as a wireless LED DMX controller. It is suitable only for indoor installation. It is
not suitable for households.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Setup Mode
In this mode you can select the type of the LEDs of the connected lighting fixture(s).
Press and hold down the MANUAL/SETUP button (25) for 3 seconds to enter setup mode. The LED on
the button starts start blinking.
Refer to 6.2.1. LEDs Type Setup on page 19 for more information about the available settings in this mode.
Press and hold down the MANUAL/SETUP button (25) for 3 seconds to exit setup mode. The LED on the
button stops blinking.
Product code: 50708
18
Fig. 09