Diffuser Installation - SHOWTEC EventDOT 15 Q4 User Manual

Table of Contents

EventDOT 15 Q4

Option 5: installation with a Velcro fastener

Remove the mounting bracket (05) from the device.

Use a Velcro snap fastener to attach the device to the

supporting structure, as shown in Fig. 13. Put the Velcro snap

fastener through the slot for Velcro (09).

Note:

The Velcro snap fastener (product code: D9581B) is not included in

the delivery. You can purchase it with any Highlite International

dealer.

Option 6: installation with a powerbox clamp

Remove the mounting bracket (05) from the device.

Use the special powerbox clamp to attach the device to the

supporting structure, as shown in Fig. 14.

Note:

The powerbox clamp (product code: 90659) is not included in the

delivery. You can purchase it with any Highlite International dealer.

Diffuser Installation

The EventDOT 15 Q4 is delivered with 3 diffusers: 15°, 30°, and a dome diffuser.

To install the diffuser, follow the steps bellow:

01) Place the diffuser above the lens (02), so that the 3 wings of the diffuser will fit into the 3 cut-outs for

diffusor installation (03) on the device, as shown in Fig. 15.

02) Push and turn the diffusor clockwise to secure it in its place, as shown in Fig. 16.

Product code: 44011

Fig. 15

Fig. 13

Fig. 14

Fig. 16

Table of Contents

Do you have a question about the EventDOT 15 Q4 and is the answer not in the manual?

44011