Weigh Sample - Ankom Flex Analyte Extractor Operator's Manual

8.4.5. Enter sample names, starting with line one. The user
can enter up to four sample names. Do not skip
positions, always start with position one, line one
and continue in order.
A vessel position will be run only when a sample
name is entered into the corresponding line. If the
user wants to run position 1 and 2, then sample
names are inputted only in line 1 and 2.
8.4.6. Press "SAVE."
NOTE:
If "SAVE" is pressed before all sample names were entered go back to the Home Screen and repeat
the Load Method steps.

Weigh Sample

8.5.1. Weigh sample into digestion vessels: For more
details on sample size per method, refer to the
SOPs of the selected methods on the ANKOM
website.
If weighing an oil sample, refer to Service
Procedure FLS007.
8.5.2. Weigh sample directly into each digestion vessel.
It is very important to not exceed the specified
sample size. Exceeding the sample size could
result in columns overloading.
Rev 1/22/2021
Operator's Manual
pg. 33