6.
Remove the equipment frame's rear
guide screws. In order to completely
lower the equipment frame on the left-
hand side, it must first be pulled back.
7.
Pull out the equipment frame. .
Assembly
1.
Push in the equipment frame. Make sure
that the height adjustment stay is
inserted into the equipment frame.
2.
Hook the springs on the equipment
frame as illustrated.
3.
Assemble the equipment frame in the
reverse order in relation to dismantling.
4.
Adjust the ground pressure, see
"Checking and Adjusting the Ground
Pressure" on page 108.
Fitting the cutting unit (CombiClip
103, CombiClip 110)
!
WARNING!
Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break
and cause personal injury.
1.
Place the Rider on a flat surface and
apply the parking brake.
2.
Check that the lever for setting the
cutting height is in the lowest position
94
English-
REPAIR INSTRUCTIONS
Rear guide screw
Equipment frame pulled forwards
Spring placement
8042-083