Checking The Engine's Oil Level, Briggs & Stratton - Husqvarna Rider 16C AWD Workshop Manual

Checking the engine's oil level,
Briggs & Stratton
Check the oil level in the engine when the
Rider stands horizontal with the engine
switched off.
Open the engine cover.
Loosen the dipstick and pull it out. Wipe off
the dipstick and fit it again.
The dipstick should be completely screwed
down.
Pull out the dipstick and read the oil level.
The oil level should be between the markings
on the dipstick. If the level is approaching the
"ADD" mark, top up the oil to the "FULL" mark
on the dipstick.
The oil is topped up through the hole the
dipstick sits in.
Fill the oil slowly. Tighten the dipstick correctly
before starting the engine. Start and run the
engine at idling speed for approx. 30 seconds.
Turn off the engine. Wait 30 seconds and check
the oil level. If necessary fill so that the oil comes
up to the "FULL" mark on the dipstick.
First and foremost use synthetic engine oil
class SJ–CF 5W/30 or 10W/30 for all
temperature ranges. Mineral oil SAE30, class
SF–CC can be used at temperatures > +5 °C
(40 ˚F).
Do not mix different types of oil.
REPAIR INSTRUCTIONS
Dipstick and filling
ADD
ADD FULL
Dipstick markings
8009-413
FULL
6008-035
English-
49