10. Release the parking brake cable from
the front axle.
11. Loosen the stop screws (2) and remove
the bearing on right-hand side.
Assembly
1.
Assemble the front axle in the reverse
order in relation to dismantling. Tighten
the left side bearing before the right
bearing.
2.
The stop screws for the bearing on right-
hand side are tightened after the five
screws holding the front axle have been
tightened.
3.
The synchronisation link is fitted in upper
the hole.
(Below the holes for the synchronisation
link is a hole for the release control)
68
English-
REPAIR INSTRUCTIONS
Rear front axle mounting
Parking Brake Cable
Right front axle bearings
Synchronisation link
8009-829
8009-691
8009-625
8042-121