Table of Contents
Advertisement
Adjusting the Unit's Parallelism and
Cutting Height
When a new cutting unit is attached, you
need to adjust the parallelism and cutting
height.
Starting position:
1.
Check the air pressure in the tyres
60 kPa/0.6 bar/9 PSI.
2.
The cutting unit shall be lowered onto a
flat surface.
3.
The height adjustment lever shall be set
to the lowest cutting height.
Parallelism
Check the cutting unit's parallelism as
follows:
1.
Check the air pressure in the tyres 60
2
kPa/0.6 kp/cm
/8.5 PSI.
2.
Place the machine on a flat surface.
3.
Put the lifting lever in the mowing
position.
4.
Measure the distance between the
ground and the front and rear edges of
the cutting unit hood. The cutting unit
should have a slight slant, with the rear
edge 2-4 mm (1/8") higher than the front
edge.
Cutting height
1.
Remove the right-hand wing cover.
2.
Raise or lower the entire cutting range by
screwing the nuts up or down
3.
Loosen the nut on the height adjustment
strut.
4.
Adjust so that the distance between
ground and the cutting unit's edge at the
front of the cover is for:
•
Combi 94
40 mm
•
Combi 103
40 mm
•
Combi 112
35 mm
REPAIR INSTRUCTIONS
Height adjustment lever
11
1
The Right-hand Wing Cover
8042-014
8042-240
3
2
6017-003
English-
107
Advertisement
Table of Contents
