Checking And Adjusting The Cutting Unit; Test Running; Starting The Engine - Husqvarna Rider 16C AWD Workshop Manual

DELIVERY AND DEALER SERVICE

Checking and Adjusting the Cutting Unit

Performed after checking the tyre air pres-
sures. See "Adjusting the Units Parallellism
and Cutting Height".

Test Running

Fill with petrol. The engine should be run on
a minimum of 87-octane unleaded petrol (not
mixed with oil). Environmentally-adapted
alkylate petrol can be used to advantage.
!
WARNING!
Petrol is highly flammable.
Observe caution and fill the tank
outdoors.
!
WARNING!
Never run the engine indoors, in
enclosed or badly ventilated areas.
Engine exhaust fumes contain
poisonous carbon monoxide.

Starting the engine

Check that the machine is in neutral and is
standing still on flat ground when the parking
brake is released.
Check that the parking brake works.
Check driving forwards (1) and in reverse (2).
Check that the starter motor does not work
when the parking brake pedal is not
actuated.
Check that the engine stops if the driver
stands from the seat when the parking brake
pedal is unactuated.
Check that the starter does not work when
the cutting unit is in the lower position.
Fuel tank
Parking brake
Forward and reverse pedals
Lower the cutting unit
8042-017
8042-009
1
2
6007-209
8042-014
25
English-