Key Beep & Backlight; Installation Procedure - Ingenico iCT250 Quick Reference Manual

ID] is selected, the terminal prompts for the clerk ID to be
entered in order to print the appropriate clerk report.
[Open Pre-Auth], select [All], or [Date] to print incomplete
•
pre- authorizations or just the ones from a specific date
(YYYY/MM/DD).
NOTE:
Settlement report will print after a successful batch.
18 – Key Beep & Backlight
Through the terminal setting menu, you configure the Key Beep setting
based on your customized needs:
At idle menu press [.,#*] for the administrator menu.
1.
2. Key in the administrator name and administrator password, and
then press [Enter].
3. Select [3] to highlight Setup Menu.
4. Use [▼] button or press [5] to highlight Term Settings and press
[Enter].
5. Select [5] to access the terminal hardware setting options.
Press [1] to highlight Key Beep.
6.
7. Select [1] for All Off, [2] for All On or [3] for Invalid Only.
8. Press [Cancel] to return to the idle menu.
To change backlight setting:
Follow steps 1-5 above.
1.
2. Press [2] to highlight Backlight.
3. Select [1] for All Off, [2] for All On or [3] for On/Key Press.
Press [Cancel] to return to the idle menu.
4.
19 – Installation Procedure
The iCT250 CounterTop terminal should be placed near a power outlet,
telephone jack and Ethernet port (if appropriate). The location should be
convenient to the user and should offer adequate ventilation and
protection.
33