Flashforge Inventor Quick Start Manual page 14

Attention: Leveling would affect print effect directly, if print result is unsatisfactory,
please do leveling again.
6. Take leveling card out, on the basis of right side extruder, put leveling card between right
nozzle and build plate. Slide leveling card back and forth and adjust thumb screw in the
meantime.
If you can move leveling card easily, please rotate thumb screw clockwise to reduce the
distance between build plate and nozzle. Otherwise, rotate thumb screw anticlockwise to
increase the distance between build plate and nozzle.
If you feel slight friction sensitivity when moving leveling card, the distance between extruder
and leveling card is proper, thus adjustment compeleted.
7. After the first leveling point completed, tap [Next]. The extruder will move to the second leveling
point. Adopt same method to adjust. After three leveling points (above knobs of three leveling
points) completed all, leveling completed. Tap [Finish] to end leveling process, tap return
arrow to go back to home screen.
8. Press build plate slowly to printer bottom.
13
Start the adjustment process
with the right nozzle, then use
the distance between the right
nozzle and build plate as a
reference.