First Print - Flashforge Inventor Quick Start Manual

1. Ensure that the build plate has been leveled
before printing.
2. Ensure that the filament has been loaded in
an appropriate approach.
3. Load the filament for a while to extrude all
the melted filament you printed last time out
of the extruder.
4. Print with ABS filament, install top cover, close
the front door. Print with PLA filament, remove
top cover, open the front door.
5. Please clean extruder before printing.
6. Do not leave the printer unattended during
operation.
Print
2. Tap [Print].
User Guide 说明书
FlashPrint 切片软件
Happy3D Software软件安装包
Test Files测试文件
4. Tap [Test Files].
Print
Delete
6. Tap [Print].
Preheat Tools
40mmCUBE-L-PLA
Print Time: 1:02
Copy

First Print

1. Insert SD card into SD card slot on the right
side of the printer.
3. Tap [SD card].
40mmCUBE-L-PLA
40mmCUBE-R-PLA
Hillbert_Cube-PLA
5. Choose [40mmCUBE-L-PLA].
Attention: Make sure that PLA filament installed
on the left extruder.
40mmCUBE-L-PLA
Print Time
L Extruder
R Extruder
Platform
7. The extruder starts to heat, once heated, the
printer will start to print.
15
0:00
25℃ / 210℃
25℃
25℃ / 50℃