Using The Zoom Function; Adjusting The Zoom Position - Panasonic HC-X1500 Operating Instructions Manual

4k
Hide thumbs Also See for HC-X1500:
Table of Contents

Advertisement

Using the zoom function

Adjust the angle of view you want to shoot.
The unit has a 24× optical zoom.
This can be expanded up to approximately 48 times (approximately 32 times in UHD recording) when the [CAMERA] menu → [SW MODE] → [i.ZOOM]
→ [ON] is set.

Adjusting the zoom position

The zoom can be operated at the following 3 locations:
≥ Zoom lever (on the grip)
≥ Zoom lever (on the handle): When the handle unit (
≥ Rear ring on the lens: When [CAMERA] menu → [SW MODE] → [REAR RING] → [ZOOM] is selected
∫ About the zoom speed
≥ The zoom speed changes with the amount that the zoom lever (on the grip) is pushed or the speed that the rear ring is turned.
≥ The zoom is at a steady rate with the zoom lever (on the handle).
Performs the zoom operation with the speed set in the [CAMERA] menu → [SW MODE] → [H.ZOOM SPEED].
@
NOTE
0 If you take your finger off the zoom lever during zoom operation, the operation sound may be recorded. When returning the zoom lever to the original
position, move it quietly.
0 When the zoom magnification is at its maximum, the subjects are focused at about 1.2 m or more.
0 When the zoom ratio is 1×, the subjects are focused at about 10 cm or more.
0 The units for the zoom ratio can be changed in the [ZOOM/FOCUS] menu. (l 77)
Using i.ZOOM
When [i.ZOOM] is set to [ON], you can zoom to a maximum of approximately 48× (32× when recording with UHD) while maintaining the beauty of high-
definition image quality.
1
Select the [CAMERA] menu → [SW MODE] → [i.ZOOM] → [ON].
≥ You can set [i.ZOOM] in a USER button so that you can use iZoom. (l 47)
≥ The zoom ratio display changes.
(For example)
j iZ00 to iZ99: Optical zoom range
j
Z99: In iZoom
@
NOTE
0 In the following case, [i.ZOOM] is fixed to [OFF]:
j When super slow recording is enabled
Chapter 5 Shooting — Using the zoom function
supplied,
X2000
A
B
Z00
- 115 -
optional) is attached to the unit
X1500
1 Zoom lever (on the grip)/
2 Zoom lever (on the handle)
<T>: Zoom in the image.
<W>: Zoom out the image.
3 Rear ring
A side: Zoom out the image.
B side: Zoom in the image.
≥ In the [ZOOM RING] menu, you can also change the turn direction for the
rear ring and change the zoom control. (l 62)
Zoom ratio
A
≥ The zoom ratio can be confirmed between [Z00]/[iZ00] (maximum wide
angle) to [Z99]/[iZ99] (maximum telephoto) on the screen display. The
value becomes higher as the unit zooms in and smaller as the unit zooms
out.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hc-x2000

Table of Contents