Panasonic HC-X1500 Operating Instructions Manual page 84

[START TRIGGER]
Sets whether to start streaming with operation of the unit or operation of the application software.
The items that can be set are as follows.
≥ [CAMERA], [RECEIVER], [RECEIVER(MULTICAST)]
(Factory setting: [RECEIVER])
[CONNECTION INFO.]
Selects the internal memory of the unit or the memory card as the reference location for the transfer destination when starting a stream with the operation
of the unit.
The items that can be set are as follows.
≥ [MEMORY], [SD CARD]
(Factory setting: [MEMORY])
[RECEIVER URL]
Enter the destination URL in following format.
≥ rtmp://(server URL):(port number)/(path)/(stream key)
≥ rtmps://(server URL):(port number)/(path)/(stream key)
[RTSP PORT]
Assigns the TCP communication port number used for initial RTSP negotiation.
(Factory setting: [554])
@ NOTE
0 The following port numbers cannot be set:
j 0, 20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670, 59000 to 61000
0 This unit is generally compatible with the RTSP protocol. The URL for RTSP requests is as follows:
rtsp://<IP address>/stream
0 [RTSP PORT] settings are not possible in the following case:
j When the setting is other than the [NETWORK] menu → [STREAMING] → [START TRIGGER] → [RECEIVER]
[MULTICAST ADDRESS]
Sets the address when using the streaming with the multicast.
(Factory setting: [239.192.0.20])
[MULTICAST PORT]
Sets the port number when using the streaming with the multicast.
(Factory setting: [37004])
[LOAD (SD CARD)]
Loads the settings file from the memory card and reflects in the menu when [CONNECTION INFO.] is set to [MEMORY].
The items that can be selected are as follows.
≥ [YES], [NO]
[SAVE (SD CARD)]
Encrypts and saves the information of the destination URL to the memory card.
The items that can be selected are as follows.
≥ [YES], [NO]
[START]
Starts streaming.
The items that can be set are as follows.
≥ [ON], [OFF]
(Factory setting: [OFF])
[WLAN PROPERTY]
Performs settings related to the wireless LAN.
[TYPE]
Sets the connection method to the wireless LAN.
[DIRECT]
[INFRA(SELECT)]
[INFRA(MANUAL)]
(Factory setting: [DIRECT])
[SSID]
Enters or displays the network name of this unit or the wireless access point (SSID).
Select the following items to set this unit's SSID.
≥ The [NETWORK] menu → [WLAN PROPERTY] → [TYPE] → [DIRECT]
Enter the SSID for this unit using 32 characters or less.
≥ Factory default value for this unit's SSID:
The model number of the unit you are using is set. (For example: [HC-X2000], etc.)
Chapter 4 Operation — Menu settings
It can connect directly without using a wireless access point to a device equipped with wireless LAN such as a tablet terminal.
Connects to the wireless access point. The access point is selected from the list.
Connects to the wireless access point. Wireless access point is entered manually.
- 84 -