Chapter 1 Introduction; Switch Description; Features - D-Link DGS-3000-28SC/A1A Hardware Installation Manual

Layer 2 gigabit stackable managed switch
Table of Contents

Advertisement

DGS-3000-28SC Layer 2 Managed Stackable Gigabit Switch Hardware Installation Guide
Chapter 1

Switch Description

Features

Ports
Front Panel Components
LED Indicators
Rear Panel Description
Side Panel Description
Switch Description
The DGS-3000-28SC is part of the Layer 2 family of D-Link's managed switch product line. The Switch provides wired
Gigabit speed access for metro and campus networks. The four embedded 10G SFP+ ports guarantee performance
during aggregation of numerous Gigabit connections. The Switch is designed as a 1U rackmount case suitable for
desktops and telecom cabinets.
Features
The list below highlights the significant protocols and features supported by the Switch.
IEEE 802.3 Ethernet Working Group
IEEE 802.3z Gigabit Ethernet transmission over Fiber for LAN
IEEE 802.3x Flow Control in full-duplex compliant
IEEE 802.3u Fast Ethernet with Auto-negotiation
IEEE 802.3ab Gigabit Ethernet transmission over Unshielded Twisted Pair (UTP)
IEEE 802.3ae 10 Gigabit Ethernet transmission over Fiber for LAN
IEEE 802.3aq 10 Gigabit Ethernet transmission over Multimode Fiber with Enhanced Equalization
IEEE 802.3az Energy-Efficient Ethernet
IEEE 802.1p Priority Queues
IEEE 802.3ad Link Aggregation Control Protocol
IEEE 802.1X Port-based and Host-based Access Control
IEEE 802.1Q VLAN
IEEE 802.1D Spanning Tree
IEEE 802.1w Rapid Spanning Tree
IEEE 802.1s Multiple Spanning Tree support
Jumbo frame to 12K Bytes
Access Control List
ISM VLAN
DHCP local relay
Single IP Management
Access Authentication Control utilizing TACACS, XTACACS, TACACS+, and RADIUS protocols
Compound Authentication
Power saving mode
Simple Network Time Protocol (SNTP)
System Log
Full- and half-duplex for all ports. Full duplex allows the switch port to simultaneously transmit and receive data. It
only works with connections to full-duplex-capable end stations and switches. Connections to a hub must take
place at half-duplex.
Unicast, broadcast, and multicast storm control
Loopback Detection (LBD)
Introduction
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-3000-28sc

Table of Contents