Forwarding Filtering - D-Link DES-3250TG User Manual

Forwarding Filtering

MAC addresses can be statically entered into the switch's MAC Address Forwarding Table. These
addresses will never age out.
Unicast Forwarding
To enter a MAC address into the switch's forwarding table, click on the Forwarding Filtering
folder on the Configuration menu and then click Unicast Forwarding:
The following fields can be set:
D-Link DES-3250TG Standalone Layer 2 Switch
P2P <No>
Figure 6- 21. Setup Static Unicast Forwarding Table window
Parameter
VLAN ID
MAC Address
edge port normally
receive BPDU packets. If a BPDU
packet is received it automatically
loses edge port status. No indicates
the port does not have edge port
status.
Select Yes or No. Choosing Yes
indicates a point-to-point
shared link. These are similar to
edge ports, however
restricted in that a p2p port must
operate in full duplex. Like edge
ports, p2p ports transition to a
forwarding state
benefiting from RSTP.
Description
Allows the entry of the VLAN ID of the
VLAN the MAC address below is a
member of − when editing. Displays
the VLAN ID the currently selected
MAC address is a member of − when
editing an existing entry.
Allows the entry of the MAC address
of an end station that will be entered
into the switch's static forwarding
table when adding a new entry.
58
should not
(p2p)
they are
rapidly thus