D-Link DES-3250TG User Manual page 75

D-Link DES-3250TG Standalone Layer 2 Switch
Figure 6- 29. Current Time window
To use SNTP, toggle the SNTP State in the Current Time: SNTP Settings section to Enabled and enter the
IP address of the relay the SNTP Primary Server and/or the SNTP Secondary Server. Enter an SNTP
polling interval in the bottom field. The default setting of 720 seconds is usually fine for most network
configurations; a greater polling frequency will draw more network resources. Click Apply to let your
changes take effect.
To complete SNTP configuration, fill in the desired values in the Current Time: Set Current Time section
and then click Apply.
Time Zone and DST
To make time zone and Daylight Savings Time changes to the SNTP configuration, click SNTP
Settings in the Configuration folder and then click Time Zone and DST:
67