D-Link DES-3250TG User Manual page 50

D-Link DES-3250TG Standalone Layer 2 Switch
DHCP
Manual
IP Address
Subnet Mask
Default Gateway
BOOTP server. If this option is set, the
Switch will first look for a BOOTP
server to provide
information before using the default or
previously entered settings.
The switch will send out a DHCP
broadcast request when it is powered
up. The DHCP protocol allows IP
addresses, network masks, and default
gateways to be assigned by a DHCP
server. If this option is set, the switch
will first look for a DHCP server to
provide it with this information before
using the default or previously entered
settings.
Allows the entry of an IP address,
Subnet Mask, and a Default Gateway
for the switch. These fields should be
of the form xxx.xxx.xxx.xxx, where each
xxx is a number
decimal form) between 0 and 255. This
address should be a unique address
on the network assigned for use by the
network administrator.
which require entries under this option
are as follows:
Determines the IP address used by the
switch for receiving SNMP and Telnet
communications. These fields should
be of the form xxx.xxx.xxx.xxx, where
each xxx is a number (represented in
decimal) between 0 and 255. This
address should be a unique address
on a network assigned to you by the
central Internet authorities.
A Bitmask that determines the extent
of the subnet that the Switch is on.
Should be of the form xxx.xxx.xxx.xxx,
where each xxx
(represented in decimal) between 0 and
255. The value should be 255.0.0.0 for
a Class A network, 255.255.0.0 for a
Class B network, and 255.255.255.0
for a Class C network, but custom
subnet masks are allowed.
IP address that determines where
packets with a destination address
outside the current subnet should be
sent. This is usually the address of a
router or a host acting as an IP
gateway. If your network is not part of
an intranet, or you do not want the
42
it with this
(represented in
The fields
is a number