D-Link DES-3250TG User Manual page 107

SNMP Host Table
Use the SNMP Host Table to set up trap recipients.
To delete an existing entry, click the selection button in the Delete column on the far right that
corresponds to the port you want to remove. To create a new entry, click the Add button, a separate
window will appear.
Parameter
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string
used to identify the SNMP engine on the switch.
D-Link DES-3250TG Standalone Layer 2 Switch
Figure 6- 65. SNMP Host Table window
Figure 6- 66. SNMP Host Table Configuration window
Host IP Address
SNMP Version
Community
String/SNMPv3
User Name
Description
Type the IP address of the remote
management station that will serve
as the SNMP host for the switch.
From the pull-down menu select:
V1 – To specifies that SNMP version
1 will be used.
V2c – To specify that SNMP version 2
will be used.
V3 – To specify that the SNMP
version 3 will be used.
Type in the community string or
SNMP V3 user name as appropriate.
99