Trimming Recorded Clips
You can extract (trim) the necessary parts of a clip
recorded in the SD card.
The trimmed clip is saved as a new file on the same
SD card as the original clip. No changes are made
to the original clip.
1 Switch to Media mode.
Switch the mode using the [MODE] selection
button on the side control panel.
2 Move the cursor to the clip to be trimmed.
Move the cursor to the clip to be trimmed using
the cross-shaped button (JKH I).
.
3 Press the [ZEBRA/5] button.
The action selection screen is displayed.
4 Select [Trim This Clip], and press the Set
button (R).
Playback of the selected clip starts.
Select Range
Deselect All
Add OK Mark...
Delete OK Mark...
FTP Upload...
Delete Clips...
Trim This Clip
1000/ 2000
282min
3840x2160
30p 150M
IN
A
OUT
TRIM
4030 20
10
0
B
.
A Guide
Operation guide
B Position bar
6 : Current position of the video
: Position to start trimming (in point)
7
: Position to end trimming (out point)
8
92
Trimming Recorded Clips
2
4
00: 00: 00.00
Jan 24,2015
12 :34 : 56
30min
0
C
11: 22: 33.00
11: 23: 44.00
00: 08: 22
C Trimming information
W or Y
: Indicates the available space in
the storage media (W or Y)
: Indicates the time code of the in
7
point
: Indicates the time code of the out
8
point
: Indicates the duration from the in
9
point to the out point
Memo :
The trimmed clip will be saved to the same card
0
slot as that of the original clip.
[Duration] appears in yellow in the following
0
durations. Trimming cannot be performed in this
case.
When [Main Menu] B [System] B [Record
0
Set] B [Record Format] B [System] is set
to "4K": 3 minutes or longer; setting other
than "4K": 10 minutes or longer.
[Duration] appears in yellow if the duration is
0
longer than the recordable time on the storage
media. Trimming cannot be performed in this
case.
When trimming starts, the display switches to
0
the Media Display 2 screen.
5 Specify the in point.
Operate buttons such as H/I or J/K to move
0
the video to the in point.
(A P87 [Playing back] )
Specify the in point by pressing the [LOLUX/
0
3] button at the point you want to start
trimming.
6 Specify the out point.
Operate buttons such as H/I or J/K to move
0
the video to the out point.
(A P87 [Playing back] )
Specify the out point by pressing the
0
[C.REVIEW/4] button at the point you want to
end trimming.
7 Perform trimming.
Press the [ZEBRA/5] button to perform
trimming.
Memo :
While trimming is in progress, you can press the
0
[CANCEL/STOP] button to return to the
thumbnail screen.
While trimming is in progress, you can press the
0
[DISPLAY] button to switch the display, but the
trimming information is displayed at all times.
When trimming the in and out point, the in point
0
trimmed may be up to one second before the
specified in point and the out point trimmed may
be up to one second behind the specified out
point.