Trimming Recorded Clips - JVC GY-HM190AG Instructions Manual

Trimming Recorded Clips

You can extract (trim) the necessary parts of a clip
recorded in the SD card.
The trimmed clip is saved as a new file on the same
SD card as the original clip. No changes are made
to the original clip.
1 Switch to Media mode.
Switch the mode using the [MODE] selection
button on the side control panel.
2 Move the cursor to the clip to be trimmed.
Move the cursor to the clip to be trimmed using
the cross-shaped button (JKH I).
.
3 Press the [ZEBRA/5] button.
The action selection screen is displayed.
4 Select [Trim This Clip], and press the Set
button (R).
Playback of the selected clip starts.
Select Range
Deselect All
Add OK Mark...
Delete OK Mark...
FTP Upload...
Delete Clips...
Trim This Clip
1000/ 2000
282min
3840x2160
30p 150M
IN
A
OUT
TRIM
4030 20 10 0
B
.
A Guide
Operation guide
B Position bar
6 : Current position of the video
: Position to start trimming (in point)
7
: Position to end trimming (out point)
8
2
4
00: 00: 00.00
Jan 24,2015
12 :34 : 56
30min
0
C
11: 22: 33.00
11: 23: 44.00
00: 08: 22
C Trimming information
W or Y : Indicates the available space in
the storage media (W or Y)
: Indicates the time code of the in
7
point
: Indicates the time code of the out
8
point
: Indicates the duration from the in
9
point to the out point
Memo :
The trimmed clip will be saved to the same card
0
slot as that of the original clip.
[Duration] appears in yellow in the following
0
durations. Trimming cannot be performed in this
case.
When [Main Menu] B [System] B [Record
0
Set] B [Record Format] B [System] is set
to "4K": 3 minutes or longer; setting other
than "4K": 10 minutes or longer.
[Duration] appears in yellow if the duration is
0
longer than the recordable time on the storage
media. Trimming cannot be performed in this
case.
When trimming starts, the display switches to
0
the Media Display 2 screen.
5 Specify the in point.
Operate buttons such as H/I or J/K to move
0
the video to the in point.
(A P80 [Playing back] )
Specify the in point by pressing the [LOLUX/
0
3] button at the point you want to start
trimming.
6 Specify the out point.
Operate buttons such as H/I or J/K to move
0
the video to the out point.
(A P80 [Playing back] )
Specify the out point by pressing the
0
[C.REVIEW/4] button at the point you want to
end trimming.
7 Perform trimming.
Press the [ZEBRA/5] button to perform
trimming.
Memo :
While trimming is in progress, you can press the
0
[CANCEL/STOP] button to return to the
thumbnail screen.
While trimming is in progress, you can press the
0
[DISPLAY] button to switch the display, but the
trimming information is displayed at all times.
When trimming the in and out point, the in point
0
trimmed may be up to one second before the
specified in point and the out point trimmed may
be up to one second behind the specified out
point.
Trimming Recorded Clips
85