Clip Continuous Rec - JVC GY-HM250U Instructions Manual

Clip Continuous Rec

In normal recording, when the recording stops,
0
the image, audio, and accompanying data from
the start till the end of the recording are recorded
as one "clip" on the SD card.
This mode allows you to consolidate several
0
rounds of "startstop recording" into one clip.
Example:
In normal recording, three clips are generated as
Recording 1, Recording 2, and Recording 3.
However, recording in this mode generates only
one clip.
Press [REC] Press [REC]
(Recording starts) (Recording resumes)
Press [REC]
(Recording pauses) (Recording pauses)
Recording 1 Recording 2
Completed Clip
(Recorded video and audio)
Recording 1 Recording 2
.
1 Set "Rec Mode" to "Clip Continuous".
(A P119 [ Rec Mode ] )
Set [Main Menu] B [System] B [Record
0
Set] B [Rec Mode] to "Clip Continuous".
The display changes ("STBY" B "STBYC").
0
2 Start recording. (Recording 1)
Press the [REC] button to start recording in
0
Clip Continuous mode.
The display changes ("STBYC" B
0
"RRECC") and the card slot status indicator
lights up in red.
80
Special Recording
Press [REC]
(Recording resumes)
Press [REC] Press and hold [REC]
(Recording stops)
Recording 3
Recording 3
3 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECC"
B "STBYC" (yellow text)).
The card slot status indicator remains lighted
0
in red.
Memo :
When the [CANCEL/STOP] button is pressed
0
while the camera recorder is paused (STBYC),
the display changes ("STBYC" (yellow text) B
"STBYC" (blinking yellow text) B "STBYC"
(white text)), and a "clip" is generated. The card
slot status indicator lights up in green.
4 Resume recording. (Recording 2)
Press the [REC] button again to resume
0
recording. The display changes ("STBYC"
(yellow text) B "RRECC").
The card slot status indicator remains lighted
0
in red.
5 Pause recording.
Press the [REC] button again to pause
0
recording. The display changes ("RRECC"
B "STBYC" (yellow text)).
The card slot status indicator remains lighted
0
in red.
6 Resume recording. (Recording 3)
Press the [REC] button again to resume
0
recording. The display changes ("STBYC"
(yellow text) B "RRECC").
The card slot status indicator remains lighted
0
in red.
7 Press and hold the [REC] button.
Recording stops and the display changes
0
("RRECC" B "STBYC"). A "clip" is
generated.
The card slot status indicator lights up in
0
green.
8 Press the [REC] button again.
The display changes ("STBYC" B
0
"RRECC") and the card slot status indicator
lights up in red.
A new "clip" is generated from here.
0