Trimming Recorded Clips - JVC GY-HM600U Instructions Manual

Trimming Recorded Clips

You can extract (trim) the necessary parts of a clip
recorded in the SD card.
The trimmed clip is saved as a new file on the same
SD card as the original clip. No changes are made
to the original clip.
1 Switch to Media mode.
Switch the mode using the [MODE] selection
button on the side control panel.
2 Move the cursor to the clip to be trimmed.
Move the cursor to the clip to be trimmed using
the cross-shaped button (JKH I).
.
3 Press the [LOLUX/3] button.
The action selection screen is displayed.
4 Select [Trim This Clip], and press the Set
button (R).
Playback of the selected clip starts.
1000/2000
282min
1920x1080
60 i HQ
IN
A
OUT
TRIM
4030 20 10 0
B
.
2
4
00: 00: 00.00
Jan 24,2012
12 :34 :56
30min
0
C
11: 22: 33.00
11: 23: 44.00
00: 08: 22
A Guide
Operation guide
B Position bar
6 : Current position of the video
: Position to start trimming (in point)
7
: Position to end trimming (out point)
8
C Trimming information
W or Y : Indicates the available space
in the storage media (W or Y)
: Indicates the time code of the
7
in point
: Indicates the time code of the
8
out point
: Indicates the duration from the
9
in point to the out point
Memo :
The trimmed clip will be saved to the same card
0
slot as that of the original clip.
[Duration] appears in yellow if the duration is 10
0
minutes or longer. Trimming cannot be
performed in this case.
[Duration] appears in yellow if the duration is
0
longer than the recordable time on the storage
media. Trimming cannot be performed in this
case.
When trimming starts, the display switches to
0
the Media Display 2 screen.
5 Specify the in point.
Operate buttons such as O/N or S/T
0
to move the video to the in point.
(A P85 [Playing back] )
Press the [USER1] button at the point you
0
want to start trimming to specify the in point.
6 Specify the out point.
Operate buttons such as O/N or S/T
0
to move the video to the out point.
(A P85 [Playing back] )
Press the [USER2] button at the point you
0
want to end trimming to specify the out point.
7 Perform trimming.
Press the [USER3] button to perform trimming.
Memo :
While trimming is in progress, you can press the
0
[CANCEL] button to return to the thumbnail
screen.
While trimming is in progress, you can press the
0
[DISPLAY] button to switch the display, but the
trimming information is displayed at all times.
When trimming the in and out point, the in point
0
trimmed may be up to one second before the
specified in point and the out point trimmed may
be up to one second behind the specified out
point.
89