Table of Contents
Advertisement
Crestron QM-FTMC
Typical Connection Diagram when Uploading
Operations & Installation Guide – DOC. 6311A
Communications can be established using a serial (RS-323) connection, or by
using a TCP/IP connection. For additional connection details, refer to
"Establishing Communications with the Control System" in the latest version of
the 2-Series Control Systems Reference Guide, Doc. 6256.
The following serial connection is unique to the QM-RMCRX-BA.
Null Modem Cable
Pins
Pins
2
2
3
3
5
5
7
7
8
8
The proc
edure in this section provides details for RS-232 communication
between the PC and the control system. If TCP/IP communication is preferre
consult the latest version of the QM-RMCRX-BA QuickMedia
Receiver/Processor Operations Guide (Doc. 6332) or the Crestro
Reference Guide (Doc. 6052). These documents are available from the Crestr
website. Refer to the following figure for a typical connection diagram when
uploading files.
NOTE: Use a standard DB9 "Null-Modem" cable for connection to a
QM-Series processor. Use a straight-through serial cable for connection
2-Series processor.
FlipTop Media Center
Connect the COM B port on the QM-RMCRX-BA
control system to one of the COM ports (usually
COM 1) on the PC. The QM-RMCRX-BA requires
the use of a null-modem RS-232 cable with DB9
female connectors on both ends. Most c
available cables are acceptable; they should have at
least five pins for transmit, receive, ground, and
hardware handshaking (pins 2, 3, 5, 7 and 8).
FlipTop Media Center: QM-FTMC • 47
ommercially
d,
n e-Control
on
to a
Advertisement
Table of Contents
