Table of Contents
Advertisement
Crestron QM-FTMC
Operations & Installation Guide – DOC. 6311A
QM-FTCMK Cable Management Plate
The QM-FTMC is shipped with a blank bottom plate. A cable management plate
is available to provide a pullout cable solution for the computer input and LAN
pass-through cables. The kit contains two 6-foot cables (computer and computer
audio).
Order the QM-FTCMK Cable Management Kit for domestic models.
•
Order the QMI-FTCMK Cable Management Kit for international
•
models.
Parts Supplied with Optional Cable Management Kit
PART DESCRIPTION
Small Cable Bushing, 5/16 inch ID, 0.5 inch OD
Large cable Bushing, 0.55 inch ID, 0.80 inch OD
Cable Support Plate
Tie Wrap
Computer RGB Cable, VGA to VGA, 6 ft long
Computer Audio Cable, 3.5 mm Stereo, 6 ft long
Tools Required:
Phillips screwdriver
•
Small flat-blade screwdriver (for connecting the VGA cable)
•
The cable support plate must be installed before mounting the QM-FTMC to a
surface. The cables are looped through the cable support plate.
1. Remove the blank bottom plate and retain the four #4 x ¼ LG black
mounting screws (the QMI-FTCMK includes four #4 x ¼ screws).
2. Place the bushings on the cables (six bushings supplied). Use the large
bushing for the VGA cable.
3. Thread the cables through the appropriate slot on the plate.
4. Snap the bushings into the plate slots.
5. Feed all the excess cable through the opening.
6. Attach the plate using the four #4 x ¼ LG black mounting screws
retained in step 1 (use the four #4 x ¼ screws included with the
QMI-FTCMK).
7. Connect the cables to the appropriate connector on the front of the
QM-FTMC.
8. The cables may be secured to the bottom bar using the supplied tie
wraps.
FlipTop Media Center
FlipTop Media Center: QM-FTMC • 19
QUANTITY
4
2
1
3
1
1
Advertisement
Table of Contents
