Industry Compliance - Crestron QM-FTCC Operations & Installation Manual

FlipTop Computer Center Crestron QM-FTCC
The international version (QMI-FTCC) is equipped with a standard IEC-320
electrical appliance coupler. The IEC (International Electrotechnical
Commission) is the international standards and conformity assessment body for
all fields of electrotechnology.
Indicators
PWR (Power)
This LED illuminates when 24 volts DC is supplied to the QM-FTCC from
Cresnet.
NET
This LED illuminates when communication between the control system and the
QM-FTCC is established (the unit is polled on the network). Illumination
indicates that the SIMPL Windows program currently loaded has a network
device defined at the same Net ID as the QM-FTCC.
Bargraphs
Two sets of eight-segment programmable red LEDs are provided that can be
programmed to display audio level settings. The LEDs display is proportional to
the input and can be set from zero to 100%. Refer to "Buttons" on page 39 for
SIMPL Windows programming details.
NOTE: Indicators are not included with NB models.
SETUP LED and Pushbutton
The QM-FTCC is Touch-Settable ID-ready. A SETUP pushbutton is located on
the bottom side of the QM-FTCC. The SETUP pushbutton and its associated
LED are used for setting a units network ID during the initial configuration of a
Cresnet system or when the device is being added/replaced.

Industry Compliance

As of the date of manufacture, the QM-FTCC has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
12 • FlipTop Computer Center: QM-FTCC
Operations & Installation Guide - DOC. 6313A