Industry Compliance; Setup; Network Wiring - Crestron TPS-4500IMPC Operation Manual

Crestron TPS-4500IMPC
CAUTION: The 10-pin RJ-45 net/video connector cable supplied by
Crestron is a custom cable and is the only one that should be used. The
end of the cable has a metal shield that is required to protect the
equipment. Using non-Crestron cables will result in damage to the
product.
BAL/COAX
While not a port, these DIP switches are used to select which video
connections (balanced or unbalanced) to use when receiving video
signals. When used with a TPS-4500 with TPS-VID-2 installed, each
composite video signal can come in on either the twisted pair (balanced)
or coaxial (unbalanced) connector. When used with a TPS-4500V or
TPS-4500 with TPS-VID-1 installed, the video signal (S-video or
composite) can be received over the twisted pair (balanced) or coaxial
(unbalanced) connectors. As long as a switch is in the appropriate
position, a signal can be connected to either the BNC or twisted-pair
connector.
To select the twisted pair connector for balanced video, the DIP switch
for the respective video source must be in the "UP" position. To use the
coaxial connector(s) for unbalanced video, the DIP switch must be in the
"DOWN" position.

Industry Compliance

As of the date of manufacture, the TPS-4500IMPC has been tested and
found to comply with specifications for CE marking and standards per
EMC and Radiocommunications Compliance Labelling (N11785).

Setup

Network Wiring

CAUTION: Use only Crestron power supplies for Crestron equipment.
Failure to do so could cause equipment damage or void the Crestron
warranty.
Operations Guide - DOC. 6163
Interface Module
Interface Module: TPS-4500IMPC • 5