Crestron QM-FTCC Operations & Installation Manual page 39

Crestron QM-FTCC
Operations & Installation Guide – DOC. 6313A
NOTE: Use an Analog Initialize to send a decimal input signal to the symbol.
QM-FTCC Basic Controls – Signal Descriptions
SIGNAL TYPE
DESCRIPTION
AND NAME
Indicates that TTL H-sync is detected on the COMPUTER
input. The feedback remains high for as long as video is
Digital output:
<RGB Detect> detected.
High/1 = Computer video detected; Low/0 = No video detected
Indicates that G/Y-sync is detected on the COMPUTER input.
The feedback remains high for as long as video is detected.
Digital output:
<YPbPr Detect> High/1 = Component video detected;
Low/0 = No video detected
Sets the source gain compensation for the COMPUTER
AUDIO source.
Analog input:
<CompForRGB_Aud>
Valid analog values range from -100d (-10dB) to +100d
(+10dB), adjustable in increments of 0.1dB (1d = 0.1dB).
Analog output: Indicates the source gain compensation being applied to the
<CompForRGB_Aud_F> COMPUTER AUDIO source.
Microphone Controls
The Microphone Controls module is built into slot 02 of the QM-FTCC. The
unit provides two microphone/line level inputs labeled MIC 1/LINE 1 and MIC
2/LINE 2, with muting, phantom power, noise gating, and level monitoring. In
addition, auto-compensation models provide 4 bands of equalization (160Hz,
500Hz, 1.2kHz, and 3kHz).
The microphone audio is routed to the MIC 1 and MIC 2 channels of the QM
output together with video and stereo program audio.
FlipTop Computer Center
FlipTop Computer Center: QM-FTCC • 35