Crestron QM-FTCC Operations & Installation Manual page 22

FlipTop Computer Center
18 • FlipTop Computer Center: QM-FTCC
Tools Required
Phillips screwdriver
•
Small flat-blade screwdriver (for connecting the VGA cable)
•
The cable support plate must be installed before mounting the QM-FTCC to a
surface. The cables are looped through the cable support plate.
1. Remove the blank bottom plate and retain the four #4 x ¼ LG black
mounting screws (four #4 x ¼ screws are included with the
QMI-FTCMK).
2. Place the bushings on the cables (six bushings supplied). Use the large
bushing for the VGA cable.
3. Thread the cables through the appropriate slot on the plate.
4. Snap the bushings into the plate slots.
5. Feed all the excess cable through the opening.
6. Attach the plate using the four #4 x ¼ LG black mounting screws
retained in step 1 (use the four #4 x ¼ screws included with the
QMI-FTCMK).
7. Connect the cables to the appropriate connector on the front of the
QM-FTCC.
8. The cables may be secured to the bottom bar using the supplied tie
wraps.
Cable Management Plate Installation
Crestron QM-FTCC
Operations & Installation Guide - DOC. 6313A