Installation - Crestron QM-FTCC Operations & Installation Manual

FlipTop Computer Center
16 • FlipTop Computer Center: QM-FTCC
Network Device Tree – Sub-Menu
5. Enter a new Net ID and press Enter.
Enter New Net ID
Repeat this procedure for each additional network device requiring a Net ID
change.

Installation

NOTE: This section does not apply to NB models.
The QM-FTCC is shipped with ten large blank buttons. You can order a variety
of button kits (sold separately) to add as many as 20 engraved or blank buttons.
Button Kits
KIT NUMBER
FT-BTNB-L
FT-BTNB-L-BLANK
FT-BTNB-S
FT-BTNB-S-BLANK
Button Installation
To replace the large buttons with small buttons, follow this procedure.
A 1/16" Allen (hexhead) wrench is required to remove the button faceplate.
1. Remove the four Allen (hex) screws that secure the button faceplate.
2. While holding adjacent buttons in place, carefully pull the button(s) to
be replaced from the rubber membrane.
Crestron QM-FTCC
DESCRIPTION
One large button engraved as desired
One large button not engraved
Two small buttons with divider engraved as desired
Two small buttons with divider, not engraved
Operations & Installation Guide - DOC. 6313A