Frick QUANTUM Maintenance Manual page 25

Volume Ratio (Vi) Range
Low (Default: 2.2)
Oil Pump (Low Oil Pressure):
Running Off
Alarm Alarm
(Differential) (Differential)
NOTE: The default settings are dependent on the type of compressor pump and it's running status as described in
the "Control Setup - Oil Setpoints" display section. These settings rarely need altered and alteration may cause
serious consequences.
Slide Valve Travel (Default: 190)
Separator Velocity Control:
Reference % (0%)
Maximum discharge pressure value: ____________ (range: 0 - 380 psig, default 225 psig)
Sales Order: C______________ Item: _________
Balance Piston Setup:
Enable Disable
Oil Log Setup:
Enable Disable
Main Oil Injection Safeties:
Enable Disable
Ram DBS Starter:
Enabled Disabled
FRICK QUANTUM COMPRESSOR CONTROL PANEL
MAINTENANCE
FACTORY SETPOINTS
High (Default: 5.0) Dead Band (0.0 - 1.00)
Alarm
delay (secs.)
(Differential)
Compression Ratio (4.00)
Output on
slide valve % slide valve %
default 70% default 60%
Fail Delay(15 - 120) sec. default 30
Actual Setpoint (5.0 - 50.0 PSIG)
default 15
Running Off
Shutdown Shutdown
(Differential)
Output off Ignore Delay
(0 - 10) min.
default 5
Shutdown
delay (secs.)
Fail Delay
(0 - 10) min.
default 2
Fail Delay(0 - 60) sec.
default 30
S90-010 M
Page 25