Installation; Two-Gang Box Mounting - Crestron C2N-SDC Operations & Installation Manual

Crestron C2N-SDC

Installation

The C2N-SDC may be mounted in a two-gang electrical box or a
4" x 4" (1900) electrical box. Ensure that you are using a box with
sufficient depth (minimum 1 ½") to accommodate the wires and
connectors required.
Screws and washers are included for both mounting locations. The nylon
cable clamps are used to secure the motor cables.
Included Mounting Hardware
QUANTITY
Tools required:

Two-Gang Box Mounting

When mounting in a two-gang electrical box, use the four 06-32 3/8" pan
head screws, two #6 washers, and two ¼" ID nylon cable clamps as in
the following illustration (wiring is not shown for clarity). Mount the
two-gang electrical box horizontally (with the mounting tabs on the left
and right sides of the box) to maintain an upright orientation of the
C2N-SDC. Refer to the following illustration.
Operations & Installation Guide - DOC. 6316
4 06-32 3/8" Pan Head
Screw
2 #6 Washers
2 08-32 3/8" Pan Head
Screw
2 #8 Washers
2 Nylon Cable Clamps
Philips screwdriver
•
Shade & Drape Motor Controller
PART
Two-Gang Electrical Box
Mounting
Two-Gang Electrical Box
Mounting
4" X 4" (1900) Electrical
Box Mounting
4" X 4" (1900) Electrical
Box Mounting
Both Mounting Methods
Shade & Drape Motor Controller: C2N-SDC • 15
APPLICATION