Table of Contents
Advertisement
Shade & Drape Motor Controller
C2N-SDC Control Signals (continued)
SIGNAL TYPE AND NAME DESCRIPTION
Analog input:
<Sh1_MaxTime>
Analog input:
<Sh1_JogTime>
Analog input:
<Sh1_LockoutTime>
Example Program
An example program for the C2N-SDC is available from the "Example
Programs" section of the Crestron website
(http://www.crestron.com/exampleprograms).
Search for C2N-SDC.zip.
Uploading
NOTE: Crestron recommends that you use the latest software and that
each device contains the latest firmware to take advantage of the most
recently released features. Please check the Crestron website
(http://www.crestron.com/updates) for the latest versions of software and
firmware. New users are required to register to obtain access to this site.
Assuming a PC is properly connected to the entire system, Crestron
programming software allows the programmer to upload programs and
projects after their development to the system and network devices.
However, there are times when the files for the program and projects are
• Shade & Drape Motor Controller: C2N-SDC
26
Defines the maximum period that Shade 1
will operate while opening or closing.
Valid values range from 10s (10 seconds) to
360s (6 minutes). Default is 10 seconds.
Defines the period that Shade 1 will jog open
or jog closed.
Valid values range from 0.05s (0.05 seconds)
to 2s (2 seconds). Default is .05 seconds.
Defines the minimum period that Shade 1
must remain in the stop state before
changing directions.
Valid values range from 0.2s (0.2 seconds) to
2s (2 seconds). Default is 1 second.
Operations & Installation Guide - DOC. 6316
Crestron C2N-SDC
Advertisement
Table of Contents
