Uploading A Simpl Windows Program - Crestron C2N-SDC Operations & Installation Manual

Crestron C2N-SDC

Uploading a SIMPL Windows Program

The SIMPL Windows file can be uploaded to the control system using
SIMPL Windows or via the Crestron Viewport.
Upload via SIMPL Windows
NOTE: A control system source file has the extension .smw.
A compiled SIMPL Windows file has the extension .spz for a 2-Series
control system, .bin for CNX generation, and .csz for CNX generation
with SIMPL+.
Upload via Crestron Viewport
File transfer | Send Program Command
Operations & Installation Guide - DOC. 6316
1. Start SIMPL Windows.
2. Select File | Open to view the "Open" window, navigate to the
SIMPL Window file (.smw), and click Open.
3. Select Project | Transfer Program.
1. Verify that the procedure for "Communication Settings" that
begins on page 27 has been performed.
2. As shown after this step, select File Transfer | Send Program
(Alternatively, press Alt+P) from the Viewport menu.
3. The "Send Program" window appears as shown after this step.
Click Browse, locate the completed file (.spz for PRO2) and
click Open. This displays the program's header information
and enables one or both of the What to Send check boxes. If the
program does not contain any SIMPL+ modules, only the
SIMPL Program check box is enabled. If it does contain
SIMPL+ modules, then the SIMPL+ Program(s) check box will
Shade & Drape Motor Controller
Shade & Drape Motor Controller: C2N-SDC • 31