Table of Contents
Advertisement
Shade & Drape Motor Controller
Two 4-pin terminal blocks for motor connections accommodate up to
14 AWG wire. Each shade or drape has connections for up drive, down
drive, common (neutral), and chassis ground (if available). Hardware
prevents both the open and close motors from operating simultaneously.
Also, firmware logic provides a minimum time delay so that both the
open and close motors are off for a short period of time when the
directions are reversed. Additional control is available via Cresnet.
Four pushbuttons on the face of the unit allow the motors to be activated
without Cresnet control, which is particularly useful when operating the
unit locally during installation.
Specifications
The following table summarizes the specifications for the C2N-SDC.
Specifications of the C2N-SDC
SPECIFICATION
Cresnet Power Usage
Default ID
Control System Update
Files
2-Series Control System
CNMSX-AV/PRO
CNRACKX/-DP
CEN/CN-TVAV
Firmware Version
Motor Input Power
Load Types
Maximum Load per Motor
Operating Temperature
Continued on the following page
• Shade & Drape Motor Controller: C2N-SDC
2
1, 2, 3
DETAILS
3 Watts (0.125 Amps @ 24 VDC)
0E
Version 3.117.CUZ or later
Version 5.14.02X.UPZ or later
Version 5.12.63W.UPZ or later
Version 5.12.63V.UPZ or later
C2N-SDC.v1.0.upg
120 VAC, 50/60 Hz, Single Phase
3-wire Bi-directional Motor
2 x 1/3 HP, 7.5 Amps per channel
(15 A maximum total)
41º to 122ºF (5º to 50ºC)
Operations & Installation Guide - DOC. 6316
Crestron C2N-SDC
Advertisement
Table of Contents
